Important features :
|
The AMPBOX is a current loop amplifier for the complete range of solar radiometers.
Many radiometers have no power supply, the measured radiation is used to create an output signal in the mV range and amplification is often required, especially when signal cables of more than 50 m are used between the radiometer and data collection equipment.
The input and output of the AMPBOX are galvanically isolated to minimize feedback and to protect the data collection equipment. When installation is in EMC-unfriendly environments, amplification can prevent interference problems.
The 4 to 20 mA interface makes it easy to connect to most data collection equipment. An output of 2 to 10 Volt can be created with the use of a 500 Ohm resistor and a suitable power supply.
As standard amplification is set to 1 mV input equals 1 mA output. On request the amplification can be adjusted to suit the sensitivity of a specific radiometer, for example with a pyranometer this results in 4 to 20 mA equals 0 to 1600 W/m².
AMPBOX is IP66 approved and suitable, like all Kipp & Zonen radiometers, for outdoor installation under all weather conditions. Two cable glands and internal screw terminals allow for easy connection of radiometer and output wires. Radiometer temperature sensors can be connected and passed through AMPBOX (without amplification).
Specifications
Input voltage range | -12 to +150 mV |
Supply voltage range (via current loop) |
7,2 VDC to 35 VDC |
Current output | 4 to 20 mA |
Gain standard | 1 mA/mV (adjustable) |
Gain range | 0,1 mA/mV to 4 mA/mV |
Dimensions ( W x D x H ) | 98 x 64 x 34 mm |
Protection degree | IP 66 |